AP121 (ar9330) U-boot

DRAM:  32 MB
led turning on for 1s...
id read 0x100000ff
flash size 4194304, sector count = 64
Flash:  4 MB
Using default environment

In:    serial
Out:   serial
Err:   serial
Net:   ag7240_enet_initialize...
Fetching MAC Address from 0x81ff4618
Fetching MAC Address from 0x81ff4618
: cfg1 0x5 cfg2 0x7114
eth0: 00:03:7f:11:40:00
ag7240_phy_setup 
eth0 up
: cfg1 0xf cfg2 0x7214
eth1: 00:03:7f:11:40:01
athrs26_reg_init_lan
ATHRS26: resetting s26
ATHRS26: s26 reset done
ag7240_phy_setup 
eth1 up
eth0, eth1
auto update firmware: is_auto_upload_firmware = 0!
Autobooting in 1 seconds
hornet> tftpboot 85000000 TP-MR3020.factory.bin
dup 1 speed 1000
Using eth1 device
TFTP from server 192.168.1.100; our IP address is 192.168.1.111
Filename 'TP-MR3020.factory.bin'.
Load address: 0x85000000
Loading: #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 ##########################################
done
Bytes transferred = 5536288 (547a20 hex)
hornet> bootm
## Booting image at 85000000 ...
   Uncompressing Kernel Image ... OK

Starting kernel ...

CPU platform: Atheros AR9330 rev 1
CPU Frequency=400 MHz
CPU DDR Frequency=400 MHz
CPU AHB Frequency=200 MHz
platform frequency: 400 MHz
CPU reference clock: 25 MHz
CPU MDIO clock: 25 MHz
arguments: 
  a0 = 00000007
  a1 = a1f8ffb0
  a2 = a1f90460
  a3 = 00000004
Cmd line:argv is invalid
Environment:
envp is invalid
Cache info:
  picache_stride    = 4096
  picache_loopcount = 16
  pdcache_stride    = 4096
  pdcache_loopcount = 8
cpu0: MIPS Technologies processor v116.147
  MMU: Standard TLB, 16 entries
  L1 i-cache: 4 ways of 512 sets, 32 bytes per line
  L1 d-cache: 4 ways of 256 sets, 32 bytes per line
  Config1=0x9ee3519e<PerfCount,WatchRegs,MIPS16,EJTAG>
  Config3=0x20
KDB: debugger backends: ddb
KDB: current backend: ddb
Copyright (c) 1992-2014 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 11.0-CURRENT #1 r271551M: Sat Sep 13 15:46:51 PDT 2014
    sbruno@alice:/home/sbruno/bsd/obj/mips/mips.mips/home/sbruno/bsd/fbsd_head/sys/TP-MR3020 mips
gcc version 4.2.1 20070831 patched [FreeBSD]
real memory  = 33554432 (32768K bytes)
avail memory = 16490496 (15MB)
random device not loaded; using insecure entropy
nexus0: <MIPS32 root nexus>
clock0: <Generic MIPS32 ticker> on nexus0
Timecounter "MIPS32" frequency 200000000 Hz quality 800
Event timer "MIPS32" frequency 200000000 Hz quality 800
argemdio0: <Atheros AR71xx built-in ethernet interface, MDIO controller> at mem 0x1a000000-0x1a000fff on nexus0
mdio0: <MDIO> on argemdio0
mdioproxy0: <MII/MDIO proxy, MDIO side> on mdio0
arswitch0: <Atheros AR7240 Ethernet Switch> on mdio0
miibus0: <MII bus> on arswitch0
ukphy0: <Generic IEEE 802.3u media interface> PHY 0 on miibus0
ukphy0:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto
miibus1: <MII bus> on arswitch0
ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus1
ukphy1:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto
miibus2: <MII bus> on arswitch0
ukphy2: <Generic IEEE 802.3u media interface> PHY 2 on miibus2
ukphy2:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto
miibus3: <MII bus> on arswitch0
ukphy3: <Generic IEEE 802.3u media interface> PHY 3 on miibus3
ukphy3:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto
etherswitch0: <Switch controller> on arswitch0
mdio1: <MDIO> on arswitch0
mdioproxy1: <MII/MDIO proxy, MDIO side> on mdio1
apb0 at irq 4 on nexus0
uart0: <ar933x> at mem 0x18020000-0x18020017 irq 3 on apb0
uart0: console (115200,n,8,1)
gpio0: <Atheros AR71XX GPIO driver> at mem 0x18040000-0x18040fff irq 2 on apb0
gpio0: [GIANT-LOCKED]
gpio0: function_set: 0x0
gpio0: function_clear: 0x0
gpio0: gpio pinmask=0x0
gpioc0: <GPIO controller> on gpio0
gpiobus0: <GPIO bus> on gpio0
ehci0: <AR71XX Integrated USB 2.0 controller> at mem 0x1b000100-0x1bffffff irq 1 on nexus0
usbus0: set host controller mode
usbus0: EHCI version 1.0
usbus0: set host controller mode
usbus0 on ehci0
arge0: <Atheros AR71xx built-in ethernet interface> at mem 0x19000000-0x19000fff irq 2 on nexus0
miiproxy0: <MII/MDIO proxy, MII side> on arge0
miiproxy0: attached to target mdio1
arge0: finishing attachment, phymask 0010, proxy set 
miibus4: <MII bus> on miiproxy0
ukphy4: <Generic IEEE 802.3u media interface> PHY 4 on miibus4
ukphy4:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT-FDX, 1000baseT-FDX-master, auto
arge0: Ethernet address: 62:73:64:29:7d:87
arge1: <Atheros AR71xx built-in ethernet interface> at mem 0x1a000000-0x1a000fff irq 3 on nexus0
arge1: finishing attachment, phymask 0000, proxy null 
arge1: Ethernet address: 62:73:64:e5:cd:c1
ath0: Vendor=0x168c, Device=0x0035
ath0: Vendor=0x168c, Device=0x0035
ath0: <Atheros AR933x> at mem 0x18100000-0x1811ffff irq 0 on nexus0
ath0: eeprom @ 0x1fff0000 (16384 bytes)
ath0: eeprom data @ 0xbfff0000
ar9300_set_stub_functions: setting stub functions
ar9300_set_stub_functions: setting stub functions
Bootstrap clock 25MHz
ar9300_attach: calling ar9300_hw_attach
ar9300_hw_attach: calling ar9300_eeprom_attach
ar9300_flash_map: unimplemented for now
Restoring Cal data from DRAM
ar9300_hw_attach: ar9300_eeprom_attach returned 0
ar9300_freebsd_setup_x_tx_desc: called, 0x0/0, 0x0/0, 0x0/0
ath0: [HT] enabling HT modes
ath0: [HT] enabling short-GI in 20MHz mode
ath0: [HT] 1 stream STBC receive enabled
ath0: [HT] 1 RX streams; 1 TX streams
ath0: AR9330 mac 512.1 RF5110 phy 2332.9
ath0: 2GHz radio: 0x0000; 5GHz radio: 0x0000
spi0: <AR71XX SPI> at mem 0x1f000000-0x1f00000f on nexus0
spibus0: <spibus bus> on spi0
mx25l0: <M25Pxx Flash Family> at cs 0 on spibus0
mx25l0: s25fl032, sector 65536 bytes, 64 sectors
ar71xx_wdog0: <Atheros AR71XX watchdog timer> on nexus0
Timecounters tick every 1.000 msec
arswitch0port1: link state changed to DOWN
arswitch0port2: link state changed to DOWN
arswitch0port3: link state changed to DOWN
arswitch0port4: link state changed to DOWN
usbus0: 480Mbps High Speed USB v2.0
md0.uncompress: GEOM_ULZMA image found
md0.uncompress: 138 x 131072 blocks
ugen0.1: <Atheros> at usbus0
uhub0: <Atheros EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus0
Root mount waiting for: usbus0
uhub0: 1 port with 1 removable, self powered
Root mount waiting for: usbus0
Root mount waiting for: usbus0
ugen0.2: <SanDisk> at usbus0
umass0: <SanDisk Cruzer Fit, class 0/0, rev 2.00/2.01, addr 2> on usbus0
umass0:  SCSI over Bulk-Only; quirks = 0x0100
umass0:0:0: Attached to scbus0
Trying to mount root from ufs:/dev/md0 []...
Mounting from ufs:/dev/md0 failed with error 22.
Trying to mount root from ufs:md0.uncompress []...
warning: no time-of-day clock registered, system time will not be set accurately
da0 at umass-sim0 bus 0 scbus0 target 0 lun 0
da0: <SanDisk Cruzer Fit 2.01> Fixed Direct Access SCSI-6 device 
da0: Serial Number 4C530001920125101102
da0: 40.000MB/s transfers
da0: 3819MB (7821312 512 byte sectors: 255H 63S/T 486C)
da0: quirks=0x2<NO_6_BYTE>
Sep 13 22:46:32 init: login_getclass: unknown class 'daemon'
*** Populating /var ..
*** Loading configuration files ..
*** Restoring from /dev/map/cfg .. 
gunzip: unknown compression format
1+0 records in
1+0 records out
0 blocks
65536 bytes transferred in 0.171057 secs (383124 bytes/sec)
*** Completed.
*** setting up hostname
*** Load kernel modules
kldload: can't load bridgestp: No such file or directory
kldload: can't load if_bridge: No such file or directory
kldload: can't load random: No such file or directory
*** bringing up loopback ..
*** Starting networking via /etc/rc.d/base/net
dev.ath.0.txq_mcastq_maxdepth: 512 -> 32
sysctl: unknown oid 'dev.ath.1.txq_mcastq_maxdepth': No such file or directory
*** Interface: arge0: start
arge0: link state changed to UP
*** Interface: arge0: done
*** Interface: bridge0: start
ifconfig: SIOCIFCREATE2: Invalid argument
ifconfig: interface bridge0 does not exist
ifconfig: interface bridge0 does not exist
ifconfig: interface bridge0 does not exist
*** Interface: bridge0: done
*** Default password/login databases ..
*** inetd
*** Done!

FreeBSD/mips (freebsd-wifi-build) (ttyu0)

login: