SrcSelectExample1.seq - Source Address Selection Examples in RFC Check #1 - 4(Prefer appropriate scope)
Rule 2: Prefer appropriate scope. If Scope(SA) < Scope(SB): If Scope(SA) < Scope(D), then prefer SB and otherwise prefer SA.
Source addresses used for this test are "preferred address".
Host and Router
SrcSelectExample1.seq [-tooloption ...] -pkt ADDR_SELECT.def -tooloption : v6eval tool option
None
This TEST performs the following Check procedures for every address group defined by Check 01 - *. *Check procedure 1. Initialize : 1.1. Set IPv6 Default Route in NUT (Default Router address = <TN-Link0-LinkLocalAddress>) 1.2. Add Candidate Source Addresses in NUT 1.3. Check Candidate Source Addresses by Ping6 (TN->NUT) 2. Send Ping6 from NUT to Destination 2.1. NUT send ICMPv6 echo request (NUT->TN) 3. Judgment : if (recive packet's Destination & Source Addresses) = (expected Destination & Source Addresses), Check pass 4. Cleanup : 4.1. Delete Candidate Source Addresses in NUT 4.2. Clear prefix list & NCE & default router list in NUT
NUT TN Default Router Destination | | | | ======(INITIALIZE)========= | | | | |<-<-<-+ | | Set IPv6 Default Route |<-<-<-+ | | Add Candidate Source Addresses | | | | |<------------+ | Echo Request to Candidate Source Addresses 1 +------------>| | Echo Reply | | | | |<------------+ | Echo Request to Candidate Source Addresses 2 +------------>| | Echo Reply | | | | ======(INITIALIZE)========= | | | | |<-<-<-+ | | Excute ping6 command | | | | +------------------------>| Echo Request | | | |
LLA(Link Local Address)
Check 01: Destination: 2001::1 Candidate Source Addresses: 3ffe::1 or LLA Result: 3ffe::1
Check 02: Destination: 2001::1 Candidate Source Addresses: LLA or fec0::1 Result: fec0::1
Check 03: Destination: fec0::1 Candidate Source Addresses: LLA or 2001::1 Result: 2001::1
Check 04: Destination: ff05::1 Candidate Source Addresses: LLA or fec0::1 or 2001::1 Result: fec0::1
* Use LLA instead of fe80::1
Check 01: PASS: Receive Echo Request & source address = 3ffe::1
Check 02: PASS: Receive Echo Request & source address = fec0::1
Check 03: PASS: Receive Echo Request & source address = 2001::1
Check 04: PASS: Receive Echo Request & source address = fec0::1
TEST PASS: Check 1 = PASS
perldoc V6evalTool
ADDR_SELECT.html "Default Address Selection for IPv6" Test Common Utility
das_rules.html "Default Address Selection for IPv6" Rules